Loading... Please wait...

August 8th 2016 FDA Rules change for all Vaping Retailers is now in effect.
We are required to age check BY LAW, this will happen after checkout and you will not notice any changes. We are now using Veratad. If you do not automatically age verify we will contact you via email before shipping your order, this may delay shipping. For more information, click here.

    Please note:
    The US Postal Service will be closed Saturday, November 11th due to Veterans Day. Age verified orders placed after 2PM on Friday the 10th will be shipped on Monday, November 13th. We apologize for any inconvenience and wish everyone a happy and safe Veterans Day.

Our Newsletter


Aspire ET-S BVC - Glassomizer Black

  • Image 1
  • Image 2
  • Image 3
RRP:
$8.49
Your Price:
$7.49 (You save $1.00)
Shipping:
Calculated at checkout
Minimum Purchase:
1 unit(s)
Maximum Purchase:
5 unit(s)
Current Stock:
22
Quantity:


Product Description

Aspire ET-S BVC - Glassomizer - Black

This is the new one (September 2014) and comes with the BVC coil, not the BDC (but it will accept either coil)

The ET-S BVC Pyrex "Glassomizer" (which means glass based clearomizer) comes with an aspire coils which is a clearomizer featuring a bottom vertical coil.  NO exposed wick, the liquid goes into the four holes on the side of the coil.  The  ET-S BDC Glassomizer has a capacity of approximately 2.0 ml of e-liquid and it comes pre-loaded with a 1.8ohm dual coil head. 

The Bottom Vertical Coil (BVC) design is a major upgrade when compared to similar single coil tanks because of the uniquely designed replaceable coil and airflow system.  It was designed differently to eliminate common issues such as an airy draw, gurgling, and leaking that users often experience with other clearomizers.  It also works to eliminate outside influences on flavor to provide a true and pure taste experience.

This item is ego threaded so will work only on ego devices, it also fit on almost every mod I have tried it on. The capacity is 3.0ml but I see about 2.5 on average with mine.

Comes with:
One ET-S BVC Pyrex clearomizer with one 1.8ohm installed coil. 
These Aspire coils have four holes.

The manufacturer states this coil is good from 3v to 5v (I like it a lot at 3.8v, gets a little burned taste at higher than 4.4v for me)
This is NOT a "kit" and does not comes in a box. 

Replacement Heads for the aspire can be found here
This will take any aspire coil.

How to fill and use your Aspire ET-S BVC Glassomizer

To fill, turn the tank upside down and remove the threaded end cap. Fill the outer portion of the tank (avoid getting e-liquid into the center airflow tube, this will cause gurgling and liquid spillage) and screw the end cap back onto the tank tightly.

This is a glass (pyrex) Tank

Return Policy on this item:
If it is DOA it will be replaced, if not, it is not under any warranty, this type of clearomizer has replacable heads, if you run into an issue with a coil after using it for a while you would need to purchase a replacement. This is also not warrantied for breakage of the inner glass, be careful with it, do not drop it. Inspect your clearomizer when you receive it for cracks.

Eric's Tips: 
Some have reported that the aspire doesn't do well with "thick" liquids, if you are vaping mostly VG then you will have a harder draw with these, they have two holes in the coil. If you run into draw issues with a thicker liquid thin it down, it will become easier.

Clean this unit out with water and let it dry, you will get a better taste upon first use.
Gurgling or Leaking can occur if liquid gets into the center airflow tube. If you experience this clear this liquid by blowing through the mouthpiece into a paper towel. The excess liquid will come out of the threaded end of the device. If this happens after it is cleaned out you may need to check that all connections are screwed down tightly or replace the head and wick assembly with a new one.

The head and wick assembly can sometimes loosen itself in shipping or when the threaded end cap is unscrewed to fill and refill. Always check that it is screwed into the bottom cap tightly tightly before screwing the cap back on. Not doing so could result in a leaking or non-working device.

Always keep it wet!  This is a dual coil and is more susceptible to burn out than a standard single coil do not run the tank completely dry. Doing so could result in a burnt or damaged wick and can cause leaking. Refill the tank when the liquid level reaches approximately 1/3 full

The lifespan of replacement heads can vary quite a bit, but following the above instructions will maximize the lifespan of the coil. Coils are not warranted for any reason.

Find Similar Products by Category

Add to Wish List

Click the button below to add the Aspire ET-S BVC - Glassomizer Black to your wish list.

You Recently Viewed...