Loading... Please wait...

August 8th 2016 FDA Rules change for all Vaping Retailers is now in effect.
We are required to age check BY LAW, this will happen after checkout and you will not notice any changes. We are now using Veratad. If you do not automatically age verify we will contact you via email before shipping your order, this may delay shipping. For more information, click here.

    Please note:
    We will not be shipping Saturday, February 24th. Age verified orders placed after 2PM on Friday the 23rd will be shipped on Monday, February 26th. We apologize for any inconvenience.

Our Newsletter

PRE-BUILT Kanthal Coil 28 awg Resistance Heating Wire - 10 Pieces

  • Image 1
  • Image 2
Calculated at checkout
Current Stock:

Product Description

PRE-BUILT Kanthal 28 awg Resistance Heating Wire - 10 Pieces

This comes 10 pieces to a bag, prebuilt coils ready to insert the silica and attach to your device. No need to wind it!

Alloy: Kanthal A-1(22% Cr, 5.8% Al,  Fe balance)
Gauge: 28 AWG (apprioximate)
Shape: Round
Ohms: 1.4 ohm -Please Note this is a LOW ohm coil.

Important Notice before you purchase:
Because this is a simply prewound kanthal wire you need to understand how it works, if you cut it short the resistance will change and be different than if you left it as is.  If you modify the length the ohms will change, be sure to test the ohms before using on any battery or mod. You will need to be able to meter, use a battery mod and battery that can handle the amp draw and current. There is NO warranty on this item and no liability for safety, this is very important, this is for specilized builders only.

I was specifically asked to carry this for specific and knoweldgable modders, this item is NOT for the average person or someone who does not know what amp draw, current or metering means.

Rebuildable atomizer coils and wicks have known risks. If you are new or unsure of what you are doing you can create a hazard for your devices and yourself.

Rebuildables are for experts, not average or beginner vapers with no multimeter, knowledge of how to use a meter, when a meter must be used, or how electronic devices work. These materials cannot safely be used by the inexperienced or those without basic knowledge of electronics.

This is because:

1. A rebuildable coil/wick must be tested carefully with a meter before it is used.
2. Faulty wicks/coils WILL damage (or worse) electronic devices.
3. New coil/wick units must be tested and then used first on an APV that has short circuit protection.
4. Improperly calculated coils can damage and destroy electronic devices if not properly calibrated and ohms/watts and amp draw is considered. This is a known issue.


Add to Wish List

Click the button below to add the PRE-BUILT Kanthal Coil 28 awg Resistance Heating Wire - 10 Pieces to your wish list.

You Recently Viewed...