Easily test the resistance of your atomizers, cartomizers or clearomizers. You can also test the output voltage of your batteries with the Omnitester. The Omnitester comes with 510/eGo threading for use with all 510 and eGo threaded parts.
The Omnitester has a built in battery and is recharged using the supplied micro USB cable. You will need to charge this occasionally, if it seems to stop working, just charge it.
To test the resistance of an item, screw it onto the Omnitester, and flip the switch to the resistance setting. The Omnitester will display the items resistive load.
To test a batteries voltage, screw the battery onto the Omnitester and flip the switch to the voltage mode. Use of manual batteries will require to press the firing button while attached. The Omnitester will then display the output voltage of the attached battery. You can also attach an atomizer and a device at the same time to test its voltage under load.
The Omnitester will display a 1 in the first digit to the left if there is no current flow from battery to the tester.
The test amperage is a mere 3 milliamps to prevent any damage to the coils in the items being tested. Accurate to 0.4%
Posted by Pierre-Olivier Vachon on 14th Apr 2014
not sure if work correctly doesnt give the same volt/ohm than my vamo 5
Posted by Steve D. on 4th Apr 2014
Works great on all mods except for the ones with kicks in them. Does not read. But my fluke meter has a tough time with kicks too. Maybe it has to be under a load.